TM 10-3930-659-20 6-19. TURN SIGNAL/EMERGENCY FLASHERS SWITCH REPLACEMENT (Con't). NOTE Note position of turn signal/emergency flashers switch to aid during Installation. 3. Remove screw (8), handle (7), nut (6), and turn signal/emergency flashers switch (3) from dash plate (9). 4. Remove lockwasher (4) from turn signal/emergency flashers switch (3).  Discard lockwasher. b. INSTALLATION 1. Position new lockwasher (4) on turn signal/emergency flashers switch (3). 2. Install turn signal/emergency flashers switch (3) on dash plate (9) with nut (6). 3. Install handle (7) on turn signal/emergency flashers switch (3) with screw (8). 4. Connect three fault monitor and dash wiring harness connectors (1) to turn signal/emergency flashers switch (3). CAUTION Use care not to overtighten screws when Installing dash plate.  Dash plate Is plastic and may be damaged if screws are overtightened. 5. Install dash plate (9) on dash housing (2) with four screws (5). TA707784 6-98