TM 10-3930-659-20 6-14. FAULT MONITOR AND DASH WIRING HARNESS MAINTENANCE. This Task Covers: a.   Repair c. Installation b.   Removal Initial Setup: Equipment Conditions: Materials/Parts: • Negative battery cables disconnected (see para- •  Marker tags (Item 33, Appendix C) • Right access door opened (see TM 1 0-3930-659-10). References: • Fault monitor module removed (see paragraph 6-5). • Lower dash cover removed (see paragraph 14-23) •   TM 10-3930659-10 Tools/Test Equipment: • General mechanic's tool kit (Item 44, Appendix F) NOTE • All  wires  should  be  tagged  before  removal.    Refer  to  paragraph  2-18  for  tagging instructions. • Refer to wiring diagrams for assistance (see paragraph 6-73). a. REPAIR NOTE • Fault  monitor  and  dash  wiring  harness  does  not  need  to  be  removed  from  forklift truck to perform repair. • Repair   of   fault   monitor   and   dash   wiring   harness   consists   of   replacement   of Identification bands, terminals, and connectors. Refer to paragraph 2-28 for repair instructions. b. REMOVAL NOTE Remove clamps and tie-down straps as necessary. 1. Disconnect fault monitor and dash wiring harness (1) from fault monitor and dash wiring harness connector (3). 2. Remove nut (2) and fault monitor and dash wiring harness connector (3) from cab (4). 6-46