| |
TM 10-3930-659-20
6-3.
STARTER MOTOR REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Equipment Conditions:
Materials/Parts:
• Negative battery cables disconnected (see para-
•
Marker tags (Item 33, Appendix C)
graph 6-43).
•
One gasket
• Battery disconnect switch in OFF position (see
•
Two lockwashers
TM 10-3930-659-10).
• Conveyorized fork attachments removed from side of
References:
forklift truck (see paragraph 17-13).
• Right engine upper sideshield opened (see TM 10-
•
TM 10-3930-659-10
3930-659-10).
Tools/Test Equipment:
• General mechanic's tool kit (Item 44, Appendix F)
• Torque wrench, 0-175 lb.-ft. (Item 52, Appendix F)
• Socket wrench set, Y in. drive (Item 54, Appendix F)
a.
REMOVAL
NOTE
• All wires and cables should be tagged before removal. Refer to paragraph 2-
18 for tagging Instructions.
• Remove tie-down straps as necessary.
1.
Pull back rubber boot (5) and remove nut (1), two cables (2), and secondary steering wiring harness terminal
leads (3) from starter motor solenoid (4).
2.
Remove nut (6) and cover (7) from starter motor solenoid (4).
3.
Remove nut (14) and two terminal leads (13) from starter motor solenoid (4).
4.
Remove screw (16) and terminal lead (15) from starter motor solenoid (4).
5.
Remove nut (10), two terminal leads (11), ground strap (9), and cable (8) from starter motor (12).
6-12
|