TM 10-3930-659-20 5-32. RADIATOR GRILLE HOUSING' AND COVER REPLACEMENT (Con't). NOTE Perform steps 7 and 8 only if radiator grille housing Is to be replaced. 7. Remove taillight and rear turn signal/emergency flashers (see paragraph 6-25). 8. Remove engine upper sideshield latches and bumpers (see paragraph 14-15). b. INSTALLATION NOTE Perform steps 1 and 2 only if Installing radiator grille housing. 1. Install engine upper sideshield latches and bumpers (see paragraph 14-15). 2. Install taillight and rear turn signal/emergency flashers (see paragraph 6-25). WARNING Use  extreme  caution  when  handling  heavy  parts.    Lifting  device  Is  required  when  parts  weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg) for a three or more person lift.  Keep clear of heavy parts supported only by lifting device. Failure to follow this warning may cause serious Injury or death to personnel. 3. Attach  suitable  lifting  device  to  center  of  radiator  grille  housing  (3)  and  position  radiator  grille  housing  on  two brackets (1). 4. Install four washers (8) and screws (9) on radiator grille housing (3). 5. Remove suitable lifting device from radiator grille housing (3). 6. Install six clips (5), nine washers (6), and screws (7) on radiator grille housing (3). 7. Connect two connectors (4). NOTE Perform step 8 if only Installing cover. 8. Install cover (2) on radiator grille housing (3). FOLLOW-ON TASKS: • Install radiator grille door (see paragraph 5-33). • Install engine hood (see paragraph 14-17). 5-91