| |
TM 10-3930-659-20
5-30.
COOLANT RECOVERY TANK AND HOSES REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Engine cool.
• Rags (Item 27, Appendix C)
•
Conveyorized fork attachments removed from side of
forklift truck (see paragraph 17-13).
References:
•
Right engine upper sideshield opened (see TM 10-
3930-659-10).
• TM 10-3930-659-10
Tools/Test Equipment:
General Safety Instructions:
•
General mechanic's tool kit (Item 44, Appendix F)
• DO NOT perform engine cooling system
maintenance
unless engine is cold.
WARNING
Servicing of engine cooling system should only be performed on a cool engine. NEVER remove
clamps or hoses when engine Is hot. Pressurized steam, hot water, or coolant will cause serious
burns.
NOTE
A suitable container should be used to catch any draining coolant. Ensure that all spills are
properly cleaned.
a.
REMOVAL
1.
Slide back clamp (9) and remove coolant recovery hose (2) from coolant recovery tank (7). Allow coolant to
drain.
CAUTION
Caution should be used when removing coolant recovery hose at clips. Clips should be lifted
gently and only enough to release coolant recovery hose. Improper handling of clips will cause
clips to break.
2.
Gently lift two clips (10) and release coolant recovery hose (2).
3.
Slide back clamp (3) and remove coolant recovery hose (2) from engine radiator (1).
4.
Slide back clamp (6) and remove coolant overflow hose (5) from coolant recovery tank (7).
5.
Remove coolant overflow hose (5) from engine compartment.
6.
Remove four screws (4) and coolant recovery tank (7) from bracket (8).
5-86
|