TM 10-3930-659-20 5-23. ACCELERATOR CABLE REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Battery disconnect switch in OFF position (see • Two special shaped spacers TM 10-3930-659-10). •    Frame  locking bar installed (see TM 10-3930-Tools/Test Equipment: 659-10). • General mechanic's tool kit (Item 44, Appendix F) •    Conveyorized fork attachments removed from side of forklift truck (see paragraph 17-13). References: •    Right engine upper sideshield opened (see • TM 10-M 10-3930-659-10 3930-659-10). •    Right side and front cab skirts removed (see paragraph 14-6). a. REMOVAL 1. Remove retainer (6), pin (5), and clevis (3) from bracket (4). NOTE Note position of accelerator cable to aid during Installation. 2. Remove  two  locknuts  (7),  washers  (8),  U-bolt  (2),  and  accelerator  cable  (1)  from  bracket  (4).    Discard locknuts, washers, and U-bolt. 5-64