TM 10-3930-659-20 4-9. STE/ICE-R NO-GO CHAIN TESTS - DCA MODE. a. The  following  NO-GO  Chain  Tests  are  made  using  the  forklift  truck's  DCA  connector.    Each  test  is referenced from the GO Chain testing sequence.  Do not perform any of these tests unless you are instructed to do so by the GO Chain testing procedure or by Table 4-1,4-2, or 4-3.  All testing is referenced by the NG (NO-GO) number. b. For normal readings, refer to the M544E Forklift Truck Test Card at Table 4-4.  For DCA test location, refer to paragraph 4-6. GO Test Page Number Test Title Number NG20 Engine No Crank - No Start Test ............................................................. 4-64 NG30 Engine Crank - No Start Test .................................................................. 4-65 NG31 Fuel System Tests .................................................................................. 4-66 NG50 Alternator Tests....................................................................................... 4-69 NG80 Starter Motor Circuit Tests ...................................................................... 4-71 NG81 Battery Tests........................................................................................... 4-75 NG90 Starter Motor Tests ................................................................................. 4-78 NG100 Engine Tests ........................................................................................... 4-79 NG110 Starter Motor Current Test....................................................................... 4-81 NG150 Engine Rotation Check............................................................................ 4-82 4-63