TM 10-3930-653-14&P WHEEL BRAKE REASSEMBLY (1) Apply brake fluid on the wheel cylinder cup and piston, and reinstall spring, cup, piston and boot in this order. (2) Install the wheel cylinder on the backing plate. CAUTION : There are two kinds of wheel cylinders and backing plates; one for the right side and one for the left side.  Make sure you have the correct one when installing it. Bolts should be torqued to 1.8-2.7 kg.m (13.0-19.5 ft.lbs). (3) Install the backing plate on the front axle Torque the mounting bolts to 1.25-1.7 kg.m(9.0-12.3 ft-lbs). (4) Apply  heat-resistant  grease  (AKEBONO’s  AKB100  or  equivalent)  on  the  points  indicated  in  Fig.    8-20,  with  due care not to contaminate the lining with grease. (a):  Backing plate shoe ledge surface. (b):  Anchor pin. (c):  Cable guide surface on which adjuster cable contacts. (d):  Parking brake lever pin. (e):  Adjuster screw and other rotating parts. Fig.  4-461. (5) Install the parking brake cable on the backing plate with E-retainer. (6) Install shoes with hold-down springs. Fig.  4-462. (7) Put the anti-rattle spring in the strut then install it on the shoe. 4-232