| |
TM 10-3930-653-14&P
DISASSEMBLY OF POWER STEERING CYLINDER
(1) Hold the power steering cylinder by a vice.
Note: Place pieces of wood between
the vice jaws and the cylinder.
Do
not
overclamp
the
cylinder.
Fig. 4-435.
(2) Raise one of the caulkings locking the cylinder cap
and remove the cylinder cap with a hook spanner.
At this time, it is a good practice to wrap vinyl tape
around the piston rod threaded part to prevent the oil
seal lip from being damaged.
Fig. 4-436.
(3) Remove the piston rod from the cylinder. Do not
separate the piston and rod.
Fig. 4-437.
(4)
Loosen the lock nut and remove the ball joint.
Note:
It is not necessary to remove
the ball joint assembly, if it is
in good condition.
Fig. 4-438.
4-217
|
