| |
TM 10-3930-653-14&P
SIDESHIFT CARRIAGE
CYLINDER & WEAR PLATE REPLACEMENT
1.
Make sure the hydraulic pressure is released by
moving the sideshift control valve back and forth
several times.
2.
Remove forks and LBR.
3.
Remove both hydraulic lines from the sideshift
cylinder.
4.
Remove the cylinder pins and remove cylinder
for access to internal parts.
5.
Unscrew cylinder cap (Item 7) with spanner
wrench and remove together with piston ram
(Item 2).
6.
Remove cotter pin (Item 16) and nut (Item 15)
from end of ram so that piston (Item 11) can be
separated from ram and ram can be taken out of
cylinder cap. Replace all software as necessary.
7.
Check inside cylinder tube (Item 17) for
scratches or grooves; repair or replace as
necessary.
8.
Reassemble cylinder.
9.
To replace lower wear bushing and upper guide
bushings, unbolt and remove lower guide (Item
36, Part Number 62016-12251).
10.
Support finger-bar with a chain-hoist and then
remove
stopper
(Item
32,
Part
Number
7826069218).
11.
Now drive out guide shaft (Item 33. Part
Number 62016-12222) and lift finger bar out of
the way.
12.
Lower wear bushing can unbolted and replaced,
and upper guide bushings can be pulled out of
guide tube and new ones pressed in as
necessary.
13. Replace O-ring in bushing and reassembly in
reverse order being sure to grease all points.
4-208
|
