TM 10-3930-653-14&P (5) Tighten bearing nut. Fig. 4-334. (6) Measure  preload  of  output  shaft.  If  reading  of gauge  is  out  of  standard  value,  adjust  with  the bearing    nut    mentioned    in    Step    (5)    above. Preload: 8 to 10 kg-cm (0.58-0.723 ft-lbs) Fig. 4-335. (7) Put in lock washer and tighten with lock nut. Tightening  torque:  150  +  50  kg-cm  (10.9+3.6 ft-lbs) Fig. 4-336. (8) Bend tangs of lock washer. Fig. 4-337. REASSEMBLY OF CASE COVER (1)   Drive roll pin into shift lever 2 or 3 mm (0.08 or 0.12 in). Fig. 4-338. (2)  Put  shift  rod  in  case  cover  and  install  shift  lever  on shift rod. Fig. 4-339. 4-174