TM 10-3930-653-14&P GENERAL DATA SECTION INTRODUCTION This manual contains operation, service and repair instructions with a parts  breakdown  for  the  TCM  Model  FG30N7(T). These    trucks    are  manufactured  by  TCM,  Shiga  Preficture,  Japan,  and  were  procured  under  Contract  DAAE07-82-C- 6720.  These trucks are built to MIL-T-52932A  (11 July 80). PURPOSE OF EQUIPMENT These internal combustion, fork lift trucks are designed for the handling, transporting and warehousing of materials over hard   surfaces.      In   this   capacity,   as   a   self-contained,   sit   down,   rider-type,   mechanized   piece   of   material   handling equipment,  they  are  completely  equipped  to  lift  and  carry  their  rated  capacity  and  lift  it  (when  stopped)  to  the  full  rated height of the upright. DESCRIPTION These  trucks  are  internal  combustion,  engine  powered,  front  wheel  drive,  rear    wheel    steering,    sit    down  rider  fork  lift trucks.    The engine supplies the power for traveling,  steering,  and lifting.  The  "drive train" consists of the engine, the torque converter and power shift transmission, and the final drive  axle.    The  steering  is  powered  by  the  hydraulic  pump through a flow divider and controlled by the steering box to  the power steering cylinder.  The lifting mechanism is powered by the hydraulic pump and controlled by the control valve to the cylinders.  There is a hydraulic fluid reservoir, integral with the frame of the truck, filters, hoist and tilt cylinders and side shift cylinder with necessary hoses and fittings. INSTALLATION Since    these  trucks    are  packed  and    shipped  in    accordance    with  manufacturer’s  standard  commercial  practices  they require  only the installation of the forks, the battery cables to be hooked up  properly,  and  all  fluid  levels  to  be  checked before they are put into operation. NOTE The  following equipment has been preserved and  packaged,  and  is  not  ready  for  operation  until the necessary   depreservation   and   "Before   Operating   Services"   have      been   performed,   according   to      form DA2258, as supplied with the equipment.  The following is  a list of applicable serial numbers:  44430227  to 44430248  inclusive. 1-1