TM 10-3930-653-14&P STANDARD VALUE FOR MAINTENANCE 1.  TORQUE CONVERTER Unit: mm (in) Checking Item Standard Value Service Limit O.D. of oil seal sliding part of pump wheel 49.967-50.000 --- (1.967-1.969) Flexible plate fitting bolt torque: kg-cm (ft-lbs) 6.2-7.4 (0.045-0.54) --- Drain plug tightening torque: kg-cm (ft-lbs) 0.92-1.2 (0.067-0.087) --- 2.  TORQUE CONVERTER HOUSING Unit: mm (in) Checking Item Standard Value Service Limit Looseness of reverse idle gear ball bearing Less than 0.2 (0.008) More than 0.2 (0.008) Looseness of output gear ball bearing Less than 0.2 (0.008) More than 0.2 (0.008) 3.  CLUTCH PACK Unit: mm (in) Checking Item Standard Value Service Limit I.D. of drive gear busing 35.025-35.050 --- (1.379-1.360) Outside thrust washer thickness 3.4-3.5 (0.134-0.138) --- Inside thrust washer thickness 2.9-3.0 (0.114-0.118) --- Composite disk thickness 2.5-2.7 (0.0984-0.106) 2.1 (0.083) Steel disk thickness 1.58-1.67 (0.062-0.066) 1.55 (0.061) Dimensions of clutch piston seal ring: 122 x 2.5 x 3.2 --- Outer dia. x width x thickness (4.8 x 0.098 x 0.126) Dimensions of clutch piston inner seal ring: 40.2 x 2.98 x 1.7 --- Outer dia. x width x thickness (1.583 x 0.117 x 0.067) Clearance between end plate and snap ring 1.2-1.8 (0.047-0.071) --- 1.0-1.6 (0.04-0.063) I.D. of clutch piston 40.2-40.25 (1.583-1.585) --- O.D. of drive gear rotating part on clutch shaft 34.989-35.000 --- (1.3775-1.378) 4-121