Explanation of Columns in Tool and Test Equipment Requirements, Section III.

TM 10-3930-644-14&P

operating conditions.

This time includes preparation time (including any necessary disassembly/assembly time),

troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform

the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol

designations for the various maintenance categories are as follows:

C ........................................................Operator or crew

O ........................................................Organizational maintenance

F .........................................................Direct Support Maintenance

H ........................................................General Support Maintenance

D .........................................................Depot maintenance

e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and

special tools, TMDE, and support equipment required to perform the designated function.

f. Column 6, Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which shall be

keyed to the remarks contained in Section IV.

C-4 Explanation of Columns in Tool and Test Equipment Requirements, Section III.

a. Column 1, Reference Code. The tool and test equipment reference code correlates with a code used in the MAC,

b. Column 2, Maintenance Category.

The lowest category of maintenance authorized to use the tool or test

equipment.