Figure 3. Cylinder Cluster Assembly (Tri-Max, High Free Lift)

TM 10-3930-644-14&P

Figure 3. Cylinder Cluster Assembly (Tri-Max, High Free Lift)

TRI-MAX AND HIGH FREE LIFT CYLINDERS

and back-up ring (12) on gland nut (3). Insert

(CLUSTER TYPE) REASSEMBLY

replacement nylon pellets (4) in nut.

1. Refer to Figure 3 and place bearing (7) on ram

4. Slide preassembled gland nut (3) over ram (6),

(6) end as shown.

and using a spanner wrench, tighten gland nut

into tube (9).

2. Ensure that all parts and ram are free of any

foreign matter and Insert ram in tube (9) as

NOTE

shown. Install and tighten the stop ring (13), if

Use same reassembly procedure on

applicable.

remaining rams and on the single

cylinder, (Tri-Max only). Ensure that

3. Preassemble packing (2) and wiper ring (1)

all parts are clean and free of foreign

within gland nut (3) ; then place "O" ring (5)

matter and that rams move smoothly

Without binding.

3-194