INSTALLATION - TM-10-3930-644-14-P0098

TM 10-3930-644-14&P

8. Inspect all mechanical parts for wear or damage

C. ADJUSTMENT - SHIFT SELECTOR

and repair or replace as necessary.

If the truck does not shift into reverse, neutral and

B. INSTALLATION

forward smoothly and completely, the shift selector

assembly should be adjusted according to the following

1. If shift lever was removed, slide collar on shaft.

procedure.

Install flanged bearing on shaft with flanged end

down. Install shift lever on shaft and position it

1. With-the engine off, remove floor and toe plates.

at location previously marked.

2. Using shift selector on shaft, shift into neutral.

2. If the location was not marked, position lever so

that it points in direction opposite to the shift

3. In neutral position the shift lever should be

selector handle and adjust to the dimension

perpendicular to a line drawn between the ends

indicated in Figure 3-2.

of the shift rod.

3. For ACC 35-55 trucks the "A" dimension (Figure

4. If it is not perpendicular, adjust the length of the

3-2) is 29.06". For ACP 40-50 trucks the "A"

shift rod (using threaded end and yoke) until the

dimension is 30.12".

proper relationship is established.

4. Install upper column bracket on front bracket

CAUTION

and secure with capscrews. Install clamp on

Be sure threaded end of shift rod

bracket.

does not protrude through yoke and

out the other side of yoke. If it does,

5. Install selector lever and shaft through lower and

selector valve movement will be

upper mounting brackets.

Position flanged

restricted.

bearing on lower bracket and secure with

capscrews. Slide collar down to flanged bearing

and tighten setscrew.

6. Connect shift rod to shift lever and secure with

washer and cotter pin.

7. Ensure that all mechanical connections have

been made and that all connections are properly

secured.

8. Start the lift truck engine.

9. Operate the shift control lever and check

alignment of the installation. If shifting is difficult

stop the engine.

10. If binding is noticed, recheck alignment of upper

bracket to shift selector shaft.

11. Check shift

rod

adjustment

(Paragraph

below).

12. When smooth shifting is assured, install shroud

and floor and toe plates.

2-57