 |
|||
|
|
|||
|
Page Title:
Figure 3-2. Baffle and Oust Cup Details |
|
||
| ||||||||||
|
|
 TM 10-3930-644-14&P
CAUTION
Air cleaner is mounted in horizontal
position. Be sure dust cup arrows
point up. (See Fig 3-2) DO NOT USE
OIL in OUST CUP. Always refer to
manufacturer's instructions on air
cleaner.
d. Install dust cup on air cleaner body. Make
certain it seals 360 degrees around the
Figure 3-2. Baffle and Oust Cup Details
body. Tighten clamp securely.
2. Optional Service Methods
CAUTION
Bottom of dust cup is marked with
arrows and the word TOP.
Air
CAUTION
cleaner is mounted in horizontal
Pre-cleaning fins on filter element are
position. Be sure dust cup arrows
not removable.
point up (Fig 3-2). 00 NOT USE OIL in
DUST CUP.
CAUTION
f. Position dust cup on air cleaner body.
Air pressure at nozzle must not
Tighten clamp securely.
exceed 100 psi. Maintain reasonable
distance between nozzle and filter
Replace filter element as follows:
element.
a. Remove wing screw and gasket washer.
The filter element can be either dry
Remove filter element.
cleaned or washed as detailed below.
a. To dry clean filter element, direct a jet of
dry clean air up and down pleats on clean
air side of element.
b. If filter element is oily and soot laden,
wash it in a solution of warm
Figure 3-3. Removing Filter Element
b. Inspect element gasket for damage.
c. Install a new or clean element. Inspect
cup gasket (if applicable) and replace if At
is damaged.
Figure 3-4. Dry Cleaning Filter Element
water and household detergent.
The
warmer (100F) the solution, the better it
will clean. Soak element for 15
2-18b
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals