| |
TM 10-3930-643-34
GENERAL SUPPORT PROPELLER AND PROPELLER SHAFTS MAINTENANCE. (cont)
16-3.
Rear Differential Carrier Assembly. (Sheet 7 of 12)
ASSEMBLY
31.
32.
33.
34.
35.
36.
37.
38.
NOTE
When replacing parts, gears must
be replaced as a matching set.
Washers must be replaced as a
q atched set.
Using an arbor press, install spacer
(49) and cups (48 and 47) to cage
(50).
Install cone (46) and bearing (44) to
gear (42).
Using retaining ring pliers, install
ring (43).
Using an arbor press, install gear
(42) to cage (50).
Install cone (45).
Rotate cage to verify normal bearing
contact.
Apply load of 6 tons with press as
shown.
Using soft iron wire and scale
indicator, measure bearing preload
torque as shown.
Bearing preload
torque should be 5 to 15 in-lb. Be
sure to measure rotating torque
and
not starting torque.
Install thinner
spacer (49) to increase or
thicker
spacer to
decrease
preload, as
required.
Go to sheet 8
16-25
|