TM  10-3930-643-34 GENERAL  SUPPORT  PROPELLER  AND  PROPELLER  SHAFTS  MAINTENANCE.  (cont) 16-3. Rear Differential Carrier Assembly. (Sheet 5 of 12) DISASSEMBLY 22. 23. 24. 25. 26. 27, Using a 5/8”   socket and socket handle, remove two bolts (36), (37) and gasket (38). Discard (38) . NOTE The  following  is  a  difference between  M10A  Forklift  models. wrench cover gasket Remove and discard seals (39 and 40) from cover (37). Seal (40) for vehicles S/N 2001 to 2903 only. Using a rubber mallet, remove items 42 thru 50 as an assembly and shim (41) from carrier (51). Using an arbor press, press items 42 thru 46 as an assembly from cage (50). NOTE Identify and mark location of all cups and cones on gear or in bearing cage. Relationship between cups and cones must be maintained  during  reassembly. Using  snap  ring  pliers,  remove  ring (43) from gear (42). Using  a  arbor  press.  remove  bearing (44) and cones (45 and 46). 28. Using a brass punch and hammer, remove cups (47 and 48) and spacer (49) from cage (50). Go to sheet 5 16-23