| |
TM 10-3930-643-34
GENERAL SUPPORT PROPELLER AND PROPELLER SHAFTS MAINTENANCE. (cont)
16-3.
Rear Differential Carrier Assembly. (Sheet 3 of 12)
DISASSEMBLY (Cont)
6.
7.
8.
9.
10.
11.
12.
13.
14.
NOTE
The following is a difference
between M10A Forklift models.
Using diagonal cutters, cut and
discard two lock wires (3) on vehicles
S/N 2000 and below and 2904 and above.
Using a 15/16” socket and socket
wrench handle, remove nut (4) and
screw (5)
from carrier (51) on
vehicles S/N 2001 to 2903 only.
Using a hammer, punch mark bearing
caps (8) and carrier (51).
Using a 15/16” socket and socket
wrench handle, remove four bolts (6),
washers (7), two bearing caps (8), and
pins (9).
Using hoist and sling, remove items
10 thru 35 as an assembly and place
on suitable work bench.
Mark location of cups (10 and 11) on
differential assembly and remove.
Using a hammer, punch mark cases (15
and 32).
NOTE
The following is a difference
between M10A Forklift models.
Using a 1/2” socket and socket wrench
handle, remove 16 bolts (12) and
washers (13) or 12 bolts (14). 16
bolts (12) and washers (13) on
vehicles S/N 2000 and below and 2904
and above or 12 bolts (14) on vehicles
S/N 2001 to 2903.
Remove case (15), gear (16) and
washer (17) .
Go to sheet 4
16-21
|
