| |
TM 10-3930-643-34
GENERAL SUPPORT PROPELLER AND PROPELLER
16-2.
Front and Rear Planetary. (Sheet
DISASSEMBLY
NOTE
The following is a difference
between M10A Forklift models,
SHAFTS MAINTENANCE.
2 of 4)
1.
Using side cutting pliers, cut and
discard lockwire (1) from planetary
carrier (17).
2.
Cut and discard lockwire
(2) on
vehicles S/N 2001 and above only.
3.
Using a 1-1/2” socket and socket
wrench handle, remove three lock
bolts (3).
4.
Using a brass punch and hammer,
drive three pins (4), dowels (5) and
spacers (6) out, through the
planetary carrier (17).
5.
Remove three spacers (7) items 8
thru 15 as an assembly.
Move two
gears assemblies to O.D. of case to
remove third gear assembly through
center hole.
NOTE
The following steps are for the
disassembly of one gear assembly.
Disassembly of the remaining two
gear assemblies is identical.
6.
Remove cone (9), spacer (10) and cone
(11).
7.
Using a brass punch and hammer,
remove cups (12 and 13), spacer
and retaining ring (15).
8.
Using a 9/16” socket and socket
wrench handle, remove two bolts
from planetary carrier (17).
(14)
(16)
Go to sheet 3
16-16
|
