| |
TM 10-3930-643-34
GENERAL SUPPORT PROPELLER
16-1.
Front Differential
DISASSEMBLY
NOTE
AND PROPELLER SHAFTS MAINTENANCE.
Carrier Assembly.
29.
30.
31.
32.
33.
34.
35.
36.
37.
38.
The following steps (29 thru 38)
are for vehicles S/N 2001 to 2903.
Using a long round nose pliers, 1-1/2
socket and socket wrench handle,
remove cotter pin (55), nut (56) and
washer (57).
Discard cotter pin (55).
Using a suitable puller, remove yoke
(58) .
Using a flat tip screwdriver, remove
deflector (59).
Using a 9/16” socket and socket wrench
handle , remove six bolts (60), washer
(61), two bolts (62), cover (63) and
gasket (64).
Discard gasket (64).
Using a rubber mallet, remove items
66 thru 75 as an assembly and shim
(65) from carrier (54).
Using an arbor press, press items 66
thru 74 as an assembly from cage
(75).
NOTE
Identify and mark location of
all cups and cones on gear or in
bearing cage. Relationship
between cups and cones must be
maintained during reassembly,
Using snap ring pliers, remove ring
(67) from gear (662).
Using a arbor press. remove bearing
(68) and cones (69 and 70).
Remove and discard seal (71) from
cage (75).
Using a brass punch and hammer,
remove cup (72) and spacer (73) and
cup (74) from cage (75).
(Sheet 6 of 13)
Go to sheet 7
16-7
|
