| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-6. Forward and Reverse Steering Gear Assembly. (Sheet 11 of 13)
ASSEMBLY
73.
When retaining ring groove in housing
is exposed, lock arbor press.
74.
Using slip joint pliers, remove guide
pins.
75.
Install new retaining ring (24). Be
sure that open space
between new
retaining ring (24) end does
not
aline with oil holes.
76.
Turn housing (42) over and position
in arbor press at forward gear side.
77.
Install plate (23).
78.
Install two washers (21) and thrust
washer (22).
Before installing friction plates
(19 and 18), friction plates must
be soaked in transmission oil for
one hour. Failure to follow this
procedure will result in damage
to the transmission.
79.
Install 18 new wave springs (20) and
nine plates (19 and 18) in the
following order:
One plate (19), two
wave springs (20) and one plate (18).
Be sure that open ends of new wave
springs (20) have bend facing up.
Each pair of new wave springs (20)
must have opens ends alined with each
other.
80. Continue stacking in order until
stack is 1 inch from top of
housing
(42).
Go to sheet 12
15-83
|
