| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-6.
Forward and Reverse Steering Gear Assembly. (Sheet 7 of 13)
CLEANING/INSPECTION
41.
Inspect shaft (40) splines for wear
and damage. Replace, if necessary.
42.
Inspect all plates, gears, housings
and cylinders for chips, cracks, wear
or missing teeth.
Replace, if
necessary.
43.
Inspect all other parts. Refer to
paragraph 2-9.
ASSEMBLY
44.
45.
46.
47.
48.
49.
Install pistons (33 and 37) in
cylinder (41).
Rotate pistons
Remove pistons
to check clearance.
(33 and 37).
Heat cylinder (41) to 275 degrees F.
With chamfered bore of
cylinder
facing splined end of shaft,
aline
oil holes of shaft (40) with oil
holes in cylinder (41).
Using insulated gloves, lower hot
cylinder (41) onto shaft (40).
Hot
cylinder (41) will position itself
correctly on shaft.
Go to sheet 8
15-79
|
