| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-6.
Forward and Reverse Steering Gear Assembly. (Sheet 4 of 13)
DISASSEMBLY (cont)
20.
Remove and discard retaining ring
(24).
21.
Remove two C clamps from plate (25).
22.
Remove plate (25).
23.
Remove nine plates (26 and 27) and 18
wave springs (28).
Discard 18 wave
springs (28).
24.
Remove two washers (29) and thrust
washer (30).
25.
Remove plate (31).
26.
Remove retainer ring (32).
COMPRESSED AIR HAZARD
Compressed air will not exceed 30
psi.
Use only
with effective
chip guarding and personal
protective
equipment
(goggles/shield, gloves, etc.).
Do not blast piston out of
housing. Use air pressure with
restraint.
Failure to follow
this procedure could result in
damage to piston or housing.
27.
Apply air pressure to reverse oil
supply port at end of shaft (40).
28.
Remove piston (33) from cylinder (41).
Go to sheet 5
15-76
|
