| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION
15-5.
Second and Third Gear
MAINTENANCE. (cont)
Assembly. (Sheet
ASSEMBLY (cont)
96.
97.
98.
99.
100.
101.
102.
Position gear (20) on shaft (39).
Install two bearings (21) in bore of
gear (20).
Rotate gear (20) back and forth to
engage teeth of gear with teeth of
clutch plate.
If gear
does not
bottom out fully, remove it and
visually aline clutch plate keeping
gear from bottoming out.
Repeat
installation procedure.
Install one race
(19),
thrust
bearing (18) and remaining race (17)
onto shaft (39).
Heat race (17) to 250 degrees F,
refer to Chapter 2.
Using insulated gloves and plastic
hammer, drive race (17) onto shaft
(39).
Using snap ring pliers, install new
retaining ring (16).
NOTE
Return M10A Forklift to original
equipment condition.
17 of 17)
END OF TASK
15-72
|
