| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION
15-5.
Second and Third Gear
ASSEMBLY (cont)
70.
71.
72.
73.
74.
75.
Install plate (12). Do
guide pins.
MAINTENANCE. (cont)
Assembly. (Sheet
not
remove
Using an adapter, gradually press
plates and springs into housing (40).
Do not press all at once. Press and
release
gradually in 1/4 inch
increments to allow springs to seat.
When retaining ring groove of housing
is exposed, lock arbor press.
Using slip joint pliers, remove guide
pins.
Install new retaining ring (11). Be
sure that open space
between new
retaining ring (11) end does not
aline with oil holes.
Turn housing (40) over and place in
an arbor press with second gear side
up.
Before installing friction plates
(26 and 27), friction plates must
be soaked in transmission oil for
one hour. Failure to follow this
procedure will result in damage
to the transmission.
76.
Install 28 new wave springs (28) and
14 plates (27) and 15 plates (26) in
the following order:
One plate (26),
two wave springs (28) and one plate
(27).
Be sure that open ends of new
wave springs (28) have bend facing up.
Each pair of new wave springs (28)
must have opens ends alined with each
other.
77.
Continue stacking in order until
stack is 1 inch from top of
housing
(40).
Go to sheet 14
15-68
13 of 17)
|
