| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-5. Second and Third Gear Assembly. (Sheet 11 of 17)
ASSEMBLY (cont)
57.
Install new preformed packing
(30)
and new seal ring (31) in piston
(29).
58.
Coat piston (29) with
clean
lubricating oil.
59.
Insert piston (29) with new preformed
packing (30) end entering cylinder
first.
60.
Using plastic hammer, tap piston (29)
into place into housing.
NOTE
The clutch housing has three oil
holes in the second gear side and
one hole in the third gear side.
61.
Install new retaining ring (37) in
second gear side of housing (40). Be
sure that open space
between new
retaining ring (37) end does not
aline with oil holes.
62.
Using a rubber mallet, install shaft
(39) and cylinder (38) as an assembly
in housing (40) with splined end of
shaft facing toward second gear side
of housing (40).
63.
Install new retaining ring (32) in
housing (40) of third gear side. Be
sure that open space
between new
retaining ring (32) end does not
aline with oil holes.
Go to sheet 12
15-66
|
