| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-3.
Transmission Assembly. (Sheet 17 of 26)
ASSEMBLY
113.
114.
115.
116.
117.
118.
119.
120.
121.
122.
123.
Position new gasket (112) and cover
(111) and using a plastic hammer tap
into place.
Using a 3/8” socket and socket wrench
handle, install two lock washers (110)
and bolts (109).
Install 19 lock washers (108) and
bolts (107).
Install bearing (105) into cover
(111) bore.
Allow bearing to
protrude 1/8 inch above cover (111)
Bearing will seat properly when
retainer (l03) is installed.
Install three seal rings (106) on
shaft of clutch pack (128). Be sure
that rings do not bind
and that
groove is deeper than seal thickness
at all points.
Position new gasket (104) and
retainer (103).
Install six lock washers (102) and
bolts (101).
Using a 3/16" socket head screw key,
install two plugs (100).
Using a 1-1/4" open end wrench,
install elbow (99).
Connect hose assembly (98).
Using a 3/4" open end wrench,
install new preformed packing (97),
two nuts (96) and new gasket (95).
Go to sheet 18
15-39
|
