| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-3.
Transmission Assembly. (Sheet 15 of 26)
ASSEMBLY
91.
92.
93.
94.
95.
96.
97.
98.
99.
100.
101.
102.
Using snap ring pliers, install two
retaining rings (125) in grooves in
gear (122).
Using a wooden dowel, press two
bearings (124) into gear (122) until
they bottom against two retaining
rings (125).
Install two sleeves (123) in two
bearings (124).
Position washer (121) on tooth side
of gear (122)*
Position items 125 thru 121 with
gear teeth up on idler shaft (117).
Using a hammer and wooden dowel,
drive idler shaft (117) down until
flush with face of web.
Using a wooden dowel, drive idler
shaft (117) back
into
original
position.
Using an arbor press, press bearing
(130) on shaft (129) until it
bottoms against shoulder on shaft
(132).
Using snap ring pliers, install
retaining ring (131) on shaft (129).
Using a rubber mallet, drive
(129) down until bearing is
with bearing bore.
Install gear (127) on shaft
counterbore in gear hub will
with retaining ring on shaft
Install clutch pack (128).
shaft
flush
(129),
index
(132).
Go to sheet 16
15-37
|
