| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-3.
Transmission Assembly. (Sheet 10 of 26)
DISASSEMBLY (cont)
59.
60.
61.
62.
63.
64.
65.
66.
67.
Using a scribe, remove two sleeves
(123), bearings (124) and retaining
rings (125) from gear (122) using a
soft metal drift punch for bearing on
tooth side of gear and a shop press
for opposite bearing.
Place a jack under clutch pack (128).
Raise jack until one leg of trans-
mission stand is about 1-1/2 inches
off the floor.
Insert drift punch through hole in
first speed driven gear and against
bearing (126) race.
Using a hammer, tap drift punch to
drive out and remove bearing (126).
Lower jack until transmission stand
is flat on floor.
Remove jack.
Tilt clutch pack (128) toward bottom
of transmission.
Remove gear (127).
Go to sheet 11
15-32
|
