| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-3.
Transmission Assembly. (Sheet 4 of 26)
DISASSEMBLY (cont)
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Using a 3/8" socket head screw key,
remove screw (12) preformed packing
(13) and washer (14) from side of
transmission housing.
Discard
preformed packing (13).
Using an 11/16" open end wrench,
remove hose assembly (15) at front of
transmission housing.
Using a 1-1/8" and 9/16" open end
wrench, remove elbow (16), plug (17),
nine bolts (18) and lockwashers (19).
Using a 9/16" open end wrench,
install two 3/8 in-16 NC forcing
screws and tighten until cover
(20)
is loose.
Remove two 3/8-16NC forcing screws.
Using a rubber mallet, remove cover
(20) and gasket (21). Discard gasket
(21)0
Remove bearing (22) from cover (20).
Using a scribe, remove and discard
two preformed packings (23).
Using a flat tip screwdriver, bend
washer (25) back from clutch pack
shaft (27).
Using a 1-1/8" socket and socket
wrench handle, remove bolt (24),
washer (25) and two seal rings (26).
Remove clutch pack (27).
Fro
disassembly of first gear, refer to
paragraph 15-4.
Go to sheet 5
15-26
|
