| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-1.
Torque Converter. (Sheet 13 of 15)
ASSEMBLY (cont)
70.
71.
72.
73.
74.
75.
76.
77*
78.
79.
If removed, using a plastic hammer,
install four spring pins (30 and 29)
into carrier (26).
Using slip joint pliers, squeeze split
sleeve (28) and install into carrier
(26) .
Install piston ring (27) onto carrier
(26) .
If removed, using an arbor press,
install bushing (34) to gear (33).
Install gear (33) to impeller (22).
Using a 1/2" socket and torque wrench,
install two clamps (32) and eight
bolts (31).
Tighten eight bolts (31)
to 21 lb-ft.
Install impeller (22) and guide wheel
(25) to carrier (26).
Mounting bolts
and spring pin bores must be aligned.
Using a 5/16" socket and torque
wrench, install two clamps (24) and
six bolts (23).
Tighten six bolts
(23) to 26 lb-ft.
Install impeller (22) on housing (40)
q aking sure the bolt holes are in
alignment.
Using an arbor press, press evenly on
both inner and outer races of bearing
(19) and install on torque converter,
output side.
Go to sheet 14
15-14
|
