| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-1. Torque Converter. (Sheet 5 of 15)
DISASSEMBLY
19.
20,
21.
22.
23.
24.
25.
26.
Using a 1/2" socket and socket wrench
handle, remove eight bolts (31) and
two clamps (32) from impeller (22),
and separate gear (33) and bushing
(34) as an assembly.
NOTE
Separate bushing (34) from gear
(33) only if inspection shows
replacement is necessary.
Using a arbor press, remove bushing
(34) from gear (33), if necessary.
Using a hammer and brass drift, drive
out items 35 thru 38 as an assembly
from housing (40).
Remove and discard seal (36) from
shaft (35).
Using snap ring pliers, remove
retaining ring (37) from shaft (35).
Using hammer and brass drift, drive
out shaft (35) from turbine (38) in
direction of arrow shown, separating
inner bearing race (39a) from turbine
(38).
Tap outer bearing assembly (39) from
housing (40) in one direction only
because of retaining ring (41) in
bearing assembly (39).
Using snap ring pliers, remove
retaining ring (41) from bearing (39).
Go to sheet 6
15-6
|
