| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-1.
Torque Converter. (Sheet 2 of 15)
DISASSEMBLY
1.
Using a 3/4" socket and socket wrench
handle, remove bolt (l), washer (2),
preformed packing (3) and yoke (4)
from torque converter assembly, output
side. Discard preformed packing.
2.
Remove four bolts (5), access cover
(6) and gasket (7). Discard gasket
(7).
3.
Remove four bolts (8), access cover
(9) and preformed packing (10).
Discard preformed packing.
4.
Using a 9/16" socket and socket wrench
handle, remove six bolts (11) and
washers (12) from torque converter
assembly, output side.
Weight of housing is approximately
80 pounds.
Use adequate hoist and
sling for lifting.
Failure to
follow this procedure may cause
damage to equipment or INJURY. If
you are injured, seek medical aid
immediately.
5.
Using hoist and sling, remove housing
(13) from torque converter assembly,
output side.
6.
Turn torque converter assembly over to
input side. Using a 9/16" socket and
socket wrench handle, remove six bolts
(14) and retainer (15).
7.
Using a 3/4" socket and socket wrench
handle , remove bolt (16), washer (17)
with spring pin (18).
Pry up spring
pin (18) with washer (17) as an
assembly.
Do not drill out spring pin
(18) from washer (17).
Go to sheet 3
15-3
|
