TM  10-3930-643-34 GENERAL  SUPPORT  ENGINE,  FUEL,  EXHAUST  AND  COOLING  MAINTENANCE. 13-13. Fuel Solenoid. (Sheet 5 of 5) ASSEMBLY 14. 15. Using a 3/4”   open  end  wrench,  install ring (15), washer (14), plunger (13), spring (12), new gaskets (12 and 11) and solenoid body (10) into cover Tighten solenoid body (10) to (8). 125  in-lb. Using  a  flat  tip  screwdriver,  install new gasket (9), cover (8), two screws (7), lock washers (6) and screws (5) in right side of engine. Tighten two screws (5) to 28 in-lb. INSTALLATION 16. Using  long  round  nose  pliers,  install new lockwire (4). 17. Using a 7/16” open end wrench, install wire assembly (3) at terminal and nut (2). 18. Install engine side access cover (1) on right side of engine compartments refer to TM 10-3930-643-20. NOTE Return M10A Forklift to original equipment  condition. END OF TASK 13-85