| |
TM 10-3930-643-34
GENERAL SUPPORT ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE.
13-8.
Pistons, Connecting Rods and Connecting Rod Bearings. (Sheet 9 of 12)
ASSEMBLY
29.
30.
31.
32.
33.
34•
Using an arbor press, install new
bushing (11), if worn, in piston (5)
and connecting rod (4) with parting
line 60 degrees to left of oil hole
in top of rod.
Bore bushing (11) to 1.6256 to 1.6258
inches.
Coat piston (5) bore and pin (10)
with moly lube.
Insert pin (10) end into piston of
connecting rod (4). Aline bore holes
of connecting rod (4) and piston (5).
Aline bushing (11) with pin (10)
hole.
Install pin (10).
Pin is loose fit
at 70 degrees F.
Using internal snap ring pliers,
install two retainers (9).
Go to sheet 10
13-57
|
