| |
TM 10-3930-643-34
GENERAL SUPPORT ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE. (cont)
13-7.
Flywheel and Housing. (Sheet 3 of 5)
REMOVAL (cont)
4.
5.
6.
7.
Attach hoist and sling to flywheel
housing (14) in front of crankcase.
Weight of flywheel and housing is
approximately 300 lbs.
Use
adequate hoist
and
sling
for
removal and installation.
Keep
area
clear of
unnecessary
personnel. Failure to follow this
procedure could result in SEVERE
INJURY.
Using a 9/16” open
four bolts (11).
NOTE
Remove oil seal and
paragraph 13-6.
end wrench, remove
wear
sleeve,
Using a 3/4” socket and socket wrench
handle, remove eight bolts
(12),
washers (13), flywheel housing
(14)
and gasket (15).
Discard gasket
(15).
NOTE
Before removal, inspect gear.
Replace if gear is cracked,
warped, chipped or
has broken
teeth.
Using a flat punch and hammer, remove
gear (16) from flywheel (6).
Go to sheet 4
13-46
|
