| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-2.
Engine Assembly. (Sheet 10 of 10)
INSTALLATION (cont)
49.
50.
51.
52.
53.
54.
55.
56.
57.
58.
59.
Using a 3/4” open and box end wrench,
connect wire assembly (10) at
connector to solenoid on starter
motor.
Using 9/16” socket and socket wrench
handle, connect ground strap (9) to
frame stud and starter motor.
Using a 3/8” open end wrench,
connect tube assembly (8) to ether
temperature switch at right side of
engine assembly.
Using an 11/16” open end wrench,
connect tube assembly (7) to filter.
Connect tube assembly (6) to front of
engine assembly.
Install cable (4) in mounting
bracket and using a 15/16” open
end wrench, tighten two nuts (4a).
Using a 7/16” socket, socket wrench
handle-and a 7/16” open end wrench,
connect cable (4) to injection pump
arm and mounting bracket.
Using long round nose pliers, connect
spring (5) to bracket on fuel pump
cover.
Using 1" and 3/4” open end wrenches,
connect hose assembly (3) at adapter.
Using a 7/16” open end wrench,
connect hose assembly (2) to
governor.
Install two new tie straps (l).
NOTE
Return M10A Forklift
equipment condition.
to original
END OF TASK
4-24
|
