TM GENERAL  SUPPORT  ENGINE,  FUEL,  EXHAUST  AND  COOLING  MAINTENANCE. 13-5. Crankshaft Main Bearings. (Sheet 2 of 4) REMOVAL 1. Remove  and  discard  six  bearing  halves (1) from crankcase. 2. Remove and discard thrust bearing half (2). 3. Remove  and  discard  six  bearing  halves (3) from six saddle caps. 4. Remove and discard thrust bearing half (4) from thrust bearing saddle cap. CLEANING/INSPECTION Dry  cleaning  solvent  P-D-680,  used for cleaning parts, is toxic and flammable.  Use  only  in  well ventilated  areas. Wear  protective goggles and gloves. Do not smoke or allow open flames or sparks in areas where cleaning solvent is used or stored. Avoid contact with eyes, skin or clothing. If contact with eyes is made, flush with cold water and seek medical attention  immediately. If contact with skin or clothing is made, flush with cold water. If  you become  dizzy  while  using  cleaning solvent, get fresh air immediately. 5. Clean crankshaft (5) with cleaning solvent  P-D-680. 6. Inspect crankshaft (5), crankcase saddles and saddle caps, refer to paragraph  13-4. 10-3930-643-34 Go to sheet 3 13-35

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business