TM  10-3930-643-34 GENERAL  SUPPORT  ENGINE,  FUEL,  EXHAUST  AND  COOLING  MAINTENANCE.  (cont) 13-4. Crankshaft. (Sheet 8 of 9) INSTALLATION (cont) 26. 27. 28. 29. 30. 31. NOTE If bearings have been removed, insure that new bearings have been installed before installing crankshaft, refer to paragraphs 13-5  and  13-9. Lubricate  bearing with Fel-Pro C-670. Place crankshaft (8) into crankcase. Remove hoist and sling. Lubricate threads of two bolts (6), twelve bolts (4 and 1) with clean engine oil. Install thrust bearing cap (7), two bolts (6), six bearing caps (3), link (2) and twelve bolts (l). After all six bearing caps (3) are installed, tighten 12 bolts (1) and two bolts (6) to 115 lb-ft. Install  six  connecting  rod  bearings caps (5) and 12 bolts (4) , refer to paragraph 13-8. Go to sheet 9 13-32