| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-2.
Engine Assembly. (Sheet 8 of 10)
INSTALLATION (cont)
36.
Using a flat tip screwdriver, connect
hose assembly
(25) to flywheel
housing in front of engine assembly.
37.
Using 15/16” and 1-1/2” open end
wrenches, connect hose assemblies (24
and 23).
38.
Using a 1/2” open end wrench, connect
drive shaft (22).
NOTE
It may be necessary to disconnect
lines of
charging
39.
Using a
wrench,
40.
Using a
connect
charging pump to install
pump on engine.
9/16” open and box end
install charging pump (20).
1-1/2” open end wrench,
hose assembly
(19) to
regulator valve.
41.
Using a 5/8” open end wrench,
connect ground cable (18).
42.
Connect hose assembly (17) to fly-
wheel housing in front of engine
assembly.
43.
Using a flat tip screwdriver, connect
heater hose assembly (16) and tighten
hose clamp to front, right side of
engine on vehicles S/N 2001 and above.
Go to sheet 9
4-22
|
