| |
TM 10-3930-643-34
GENERAL SUPPORT ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE. (cont)
13-1.
Front Cover. (Sheet 5 of 6)
INSTALLATION
16.
17.
18.
19.
20.
21.
22.
23.
24.
Using a flat brass punch and hammer,
install three cups (27) in cover
(20).
Using a 3/8” box and open end wrench,
install two plugs (26).
Using flat brass punch and hammer,
install indicator (25).
Install two balls (24).
Position new gasket (23) in rear of
engine.
Using 1/2” socket and socket
wrench
handle, install two 5/16-18” bolts
with heads removed on
oil pick-up
tube and position new gasket (23) on
bolts .
New gasket (23) must be cut
to fit section of oil pan.
Position new gaskets (22 and 21) and
cover (20).
Position guide bolts in oil pick-up
tube alining holes in cover (20).
Using a 9/16” socket and socket
wrench handle, install four
washers
(19) and bolts (18) in bottom, rear
of engine.
Go to sheet 6
13-6
|
