| |
TM 10-3930-643-34
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE.
12-19.
Hydraulic Reservoir and Filter. (Sheet 11 of 11)
INSTALLATION
63.
64.
65.
66.
67.
68.
69.
70.
71.
Using a 9/16” socket, socket wrench
handle and a 9/16” box and open end
wrench, install bolt (20), clamps (19
and 18) and nut (17) to right side of
hydraulic reservoir (35).
Using a 3/4” socket and socket wrench
handle, connect tube assemblies (16
and 15), and install two flanges
(14), four bolts (13) and locknuts
(12) to front bottom of hydraulic
reservoir.
Using a 9/16” open end wrench,
install adapter (11) to rear of
hydraulic reservoir (35).
Connect tube assembly (10).
Using a 1-1/4” open end wrench,
install adapter (9) and indicator
(8).
Connect harness
assembly (7) at
connector.
Using a cross tip screwdriver,
install four lock washers (6) and
screws (5) to left side of hydraulic
reservoir (35) .
Using slip joint pliers,
connect
harness assembly (4) at connector.
Using a 9/16” socket and socket
wrench handle, install plate (3),
four washers (2) and bolts (1) in
vehicles S/N 2001 and above.
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
12-180
|
