| |
TM 10-3930-643-34
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE. (Cont)
12-19.
Hydraulic Reservoir and Filter. (Sheet 8 of 11)
ASSEMBLY (Cont)
37.
Using a 1/4” socket and socket wrench
handle,
install filter indicator (74)
and two screws (73) on filter head
assembly (71).
38.
Using a 1/2” socket and socket wrench
handle, install new preformed packing
(72), filter head assembly (71), four
washers (70) and bolts (69) on
hydraulic reservoir.
39.
Using an 11/16” socket, socket wrench
handle and an open end wrench,
install couplings (68 and 67), link
(66), two bolts (65) and locknuts
(64) on tube assembly (15).
40.
Using a 5/8” and 1/2” socket and
socket wrench handle, install new
preformed packing (63), tube assembly
(15) bolts (62 and 61) on filter head
assembly (71).
41.
Using an air hammer and backing bar,
install latch (60) and two new rivets
(59 to panel.
42.
Install spring (58), panel (57) and
four new rivets (56) to panel (55).
43.
Install plates (54 thru 51) and 16
key washers (50 to hydraulic
reservoir (35).
44.
Using a 14” adjustable wrench,
install new preformed packing (49),
adapter (48), plug cock (47) and plug
(46).
45.
Using a 1-1/4”
socket and torque
wrench, install new preformed packing
(450) and indicator (44).
Tighten
indicator (44) to 250 to 300 lb-ft.
Go to sheet 9
12-177
|
