TM 10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE.  (cont) 12-14. Sideshift Cylinder (S/N 2001 and above). (Sheet 9 of 11) ASSEMBLY 32. Using  an  arbor  press,  install  bushing (24) on vehicle carriage assembly. NOTE Lubricate  all  preformed  packings, wipers, seals.   sliding parts and housing  before  installing. 33. Install new seal (23), in retainer 34. 35. 36. 37. 38. 39. (13). Make sure the lips of seal (23)   face   inside   barrel   (12).   Use seal installer tool if necessary. Install new wiper (22) , new ring (21) and new seal (20 on retainer (13). Install retainer (13) on rod (19). Install new seal (18 and 17) on piston (16) . Using a 14"   adjustable  wrench, install items 18 thru 16 as an assembly and nut (15) on rod. Aline holes in nut (15) with hole in rod (19) and install pin (14). Install items 19 thru 13 as an assembly in barrel (12). 40. Using  a  spanner  wrench,  tighten retainer (13) and items 19 thru 14 as an assembly in barrel (12). 41. Using slip joint pliers , install wire (11). Go to sheet 10 12-129