| |
TM 10-3930-643-34
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE.
12-14.
Sideshift Cylinder (S/N 2001 and above). (Sheet 4 of 11)
REMOVAL
11.
12.
13.
14.
15.
NOTE
Tag all hose and tube assemblies
before disconnecting to aid in
installation.
Using a 7/8” open end wrench,
disconnect hose assemblies (3 and 4)
from cylinder assembly (10) of
vehicle carriage assembly.
Using a 7/8” open end wrench, remove
two unions (5) and preformed packings
(6).
Discard preformed packings (6).
Using a 1-13/16” socket and socket
wrench handle, loosen nut (7) enough
to show a small gap between nut (7)
and left mounting bracket.
Using a rubber mallet, drive cylinder
assembly (10) free of pin (9).
Use
soft hammer and protect cylinder
assembly with wood block.
Using a 1-13/16” socket and socket
wrench handle and long round nose
pliers, remove nut (7), washer (8)
and pin (9).
Observe position of
washer (8) to aid in installation.
Go to sheet 5
12-124
|
