TM  10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE.  (cont) 12-12. Lift Cylinder. (Sheet 2 of 10) REMOVAL NOTE The following is a procedure for removal/installation  of  right  side lift cylinder. The  procedure  for left side lift cylinder is identical. 1. Remove  fender  (1)  from  front,  right side of vehicle,   refer to TM 10-3930- 643-20. Remove fender and ladder for left side lift cylinder. 2. Position forks so boom ends are approximately  two  feet  off  ground. 3. Block securely in place. Weight  of  lift  cylinder  is  approx- imately 260 lbs. Use  adequate hoist and sling for removal and installation. Keep area clear of unnecessary  personnel. Failure to follow  this  procedure  could  result in SEVERE INJURY. 4. Position  hoist  and  sling  on  cylinder assembly (48) , making sure the sling is rapped under tube assembly (19), and take up slack. 5. Using a 1-1/8”   socket and socket wrench handle, remove bolt (2), washer (3) and pin (4) from top of lift cylinder. Do not attempt to retract rod if it is bent. 6. Start engine and move lift control lever to LOWER position to retract rod . Turn engine off and vent hydraulic  pressure,  refer  to  TM  10- 3930-643-10. Go to sheet 3 12-102