TM  10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE. 12-11. Lifting Forks and Carriage Assembly. (Sheet 12 of 15) ASSEMBLY 61. 62. 63. 64. 65. 66. 67. Using a 1-1/8” socket and torque wrench,    install seven washers (70), plate (69), plates (68), seven washers (67) and bolts (66). Tighten seven bolts (66) to 290 lb-ft. If interference  is  found  between frame (82) and plate (68), install 3/4 inch flat washers between plates (69) and (68). Shim to a clearance of 0.010 inch with shim (85). Using a 3/8”   socket and socket wrench handle, install two lubrication fittings (65). Using a 1-1/8” socket and socket wrench  handle,  install shim (64), plate (63),   washers (62) and two bolts (61). Install the least amount of shims (64) possible to obtain no preload on bearing (68). Remove hoists and slings. Using snap ring pliers, install two retaining  rings  (59),  rollers (58), retaining rings (57), covers (56) and retaining rings (55) on apron (60). Using a 1-1/8” socket and socket wrench handle, install claw (54), seven washers (53) and bolts (52). Attach hoist and sling to apron (60). Go to sheet 13 12-97