| |
TM 10-3930-643-34
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE.
12-10. Boom Assembly. (Sheet 11 of 11)
INSTALLATION
53.
54.
55.
56.
57.
58.
59.
60.
61.
Using a 1-1/4” socket and socket
wrench handle, install items 21 thru
18 as an assembly, washers (17 and
16), pin (15), washer (14) and bolt
(13)*
Use washers (17 and 16) as
shims to maintain a maximum gap of
0.031 inch between sides of rod (21)
and lever (31) and between rod (21)
and vehicle frame.
Remove hoist and sling.
Using a 15/16” open end wrench,
connect hose assembly (12) to tube
assembly (11).
Using a 1/2” socket and socket wrench
handle, install three clamps
(10),
six washers (9) and bolts (8).
Using a 15/16” open end wrench,
connect hose assembly (7) to tube
assembly (6) to front, right side of
vehicle.
Using a 1/2” socket and socket wrench
handle, install three
clamps (5),
clips (4), six washers (3) and bolts
(2).
Install pin (1) to lock boom support
(43) in place, for vehicles S/N 2001
and above.
Lubricate all lubrication fittings,
refer LO 10-3930-643-12.
Remove two jack stands and hydraulic
jack from rear of vehicle.
NOTE
Return M10A Forklift to
original
equipment condition.
END OF TASK
12-85
|
